Stock engine without internal modifications. DSG gearbox and CAN stream support. Fuel RON 98.
The only modification to the engine hardware is a replaced downpipe without a catalytic converter:
    The original ADV sensor was removed, and the opening was sealed.
    An LSU49 sensor was installed in the downpipe.

The map was calibrated on a dynamometer:
    Power: 305 HP
    Torque: 394 Nm
    Boost pressure: 100 kPa (1.0 bar)

Setup Details:
    ECU: EMU PRO 16 + Ecumaster GDI Driver

The attached map controls the following:
    GDI injectors
    GDI high-pressure fuel pump
    Low-pressure fuel pump
    Knock control
    CAN stream for Seat Cupra body (MQB platform)
    DSG DQ250 transmission
    Electronic throttle
    Electronic thermostat with SENT protocol position sensor
    Electronic wastegate
    Electronic blow-off valve (BOV)
    Variable valve timing
    Audi Valvelift System (AVS)
    Intake flaps
    PWM radiator fan

Non-mapped or unsupported features:
    No control for port injectors
    No control of the piston cooling oil jet valve (default: always on)
    No control of the oil pressure regulation valve (default: high pressure)
    No control of the cylinder deactivation valve (default: all cylinders active)
    No control of the air conditioning compressor

Revision history:
2025/01/17 v1.0 Initial release